Filter
Top Products
Chapter 2 Cajun P332MF Front and Back Panels
10 Cajun
P332MF User’s Guide
Note: To perform “Force Initial Version” reset the module and at the same time
press the FIV reset button (use an opened paper clip or other pointed object).
Release the reset buttons first and 1 or 2 seconds later, release the FIV button.
Note: The Port LEDs of the P332MF are numbered from 1-12. Expansion sub-
module ports are numbered from 51. Port LED numbers 49-50 are reserved.
FC
Symmetric Flow
Control
OFF – No Flow Control only and/or while in
half duplex mode
ON – Symmetric/Asymmetric Flow Control
mode is enabled and port is in full duplex
mode.
Hspd High Speed 10/100
1000
OFF: 10 N/A
ON: 100 1000
LAG
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 2.2 Cajun P330 <- -> Select buttons
Description Function
Left/Right Individual – select LED function (see table above).
Reset module Press both right and left buttons together for approximately two
seconds. All LEDs on module light up until buttons are released.
Reset stack Press both right and left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
FIV Force Initial Version – boot from backup initial version of the
Cajun P330 software, from Bank A (see Note below).
Table 2.1 Cajun P332MF LED Descriptions
LED Name Description LED Status