Filter
Top Products
13
Important:
• The select, double click, cancel and start/stop buttons are used for PC control. See page 45.
• To save battery power, turn off the operation indicator by pressing the START/STOP button when
not in use.
• To save battery power, the operation indicator will turn off if the remote control is not operated
for a period of 5 minutes.
Battery installation
Use two AA size batteries.
1. Remove the back cover of the remote control by pushing the battery compartment door in the
direction of the arrow.
2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).
3. Replace the back cover.
Important:
1. Do not use a new battery with an old one.
2. Load batteries in the correct position.
3. Do not heat, take apart, or throw batteries into fire.
4. Do not try to recharge batteries. Do not use rechargeable batteries.
5. If the alkaline solution of alkaline batteries comes in contact with your skin or clothes, rinse with
water. If the solution comes in contact with your eyes, rinse them with water and then consult
your doctor.
Operation with remote control for PC mode or cursor operation mode
To move the cursor, press the START/STOP button to ON and move the head of the remote control in
the direction you want the cursor to move. This remote control gives you complete 360˚ control of the
cursor direction.
12 3
Move to rightMove to left
Move upward
Move downward
Important:
Point the remote control at the projection screen or at the front or rear of the projector. The range for
optimum operation is about 25 feet. If you point the remote at the projection screen, the distance to
the screen and back to the projector must be less than 25 feet.