Filter
Top Products
3
COMPLIANCE NOTICE OF FCC
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference when the equipment is operated in a commer-
cial environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harm-
ful interference to radio communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus as set out in the interference-causing equipment standard entitled “Digi-
tal Apparatus”, ICES-003 of the Department of Communications.
Changes or modifications not expressly approved by Mitsubishi could void the user's au-
thority to operate this equipment.
COMPLIANCE NOTICE OF INDUSTRY CANADA
This Class [A] digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
WARNING
Use the attached specified power-supply cord. If you use another cord, it may cause inter-
ference with radio and television reception.
Use the attached VGA cable, RS-232C cable with this equipment so as to keep interference
within the limit of a Class A device.
The projector automatically shuts off when the lamp is used up in
about 1,300 hours and not used until lamp replacement.
DO NOT LOOK DIRECTLY INTO THE LENS WHEN PROJECTOR IS IN THE POWER
ON MODE.