Filter
Top Products
32
USER PRESETS menu
If you select USER and press the ENTER button, the user setting menu appear.
Use to adjust the horizontal position of the image. The image moves to the right as
the number increases.
Use to adjust the vertical position of the image. The image moves down as the
number increases.
Use to match the clock signals of the projector with the input signal to avoid image
noise such as wide stripes.
Use to adjust the height of the image. The image size grows higher as the number
increases. (Normally, there is no need for adjustments.)
Use to adjust the width of the image. The image size grows wider as the number
increases. (Normally, there is no need for adjustments.)
Use to synchronize the projector with PC input signals so that the image is not
blurred.
Use to adjust the level of luminance. The projector does not need this adjustment
for ordinary use. If you use a PC video card or something similar, the lighter colors
of the projected image may become blurred. In this case, adjust CLAMP.
When the equipment (DVD player system, etc.) with Y, Cb, Cr connectors is con-
nected to the PC-1 or PC-2 connector, select [Y, Cb, Cr]. Depending on the DVD
player, the image may not be projected correctly with this projector.
ENHANCED
HELP
NORMAL
POINTER
AUDIO
OPTION
QUIT
RETURN
USER
PRESETS
H-POS / V-POS
TRACKING
WIDTH / HEIGHT
FINE
SYNC
CLAMP
RGB/
Y,Cb,Cr
RGB
Y,Cb,Cr
MEMORY
0
0
0 0 0 0
0
H-POS WIDTH
HEIGHT
V-POS
H-POS
V-POS
TRACKING
HEIGHT
WIDTH
FINE
SYNC
CLAMP
RGB /
Y, Cb, Cr
Menu operation (continue)
The simple way of adjustment
1. Horizontal position:
Adjust the start position (the left end) using H-POS, and adjust the end position (the right end)
using TRACKING. Then repeat these steps.
2. Vertical position:
Adjust the start position using V-POS.
• If you change the settings of the USER PRESETS, you must select MEMORY and press the
ENTER button.
• The projector is able to memorize 2 signals setting. When reached over 2, settings of the signals
will be deleted in chronologic order.
• By pressing the + button, you can change the setting among the default condition and memorized
condition.