Filter
Top Products
22
DataTalker Owner’s Manual
When you established communication, the Main Menu appeared. From the Main Menu you can
configure the unit, display statistics, reset various functions within the DataTalker, and run
diagnostic tests:
Main Menu
1 - Configurations
2 - Statistics
3 - Reset Options
4 - Diagnostics
5 - Exit Command Mode
6 - QUICK SETUP
Selection : _
To configure the DataTalker, enter 1 and press ENTER.
The Configurations menu is displayed. From this menu you can configure the data port, voice/fax
channel(s), or the composite link. You can also select various factory defaults and store your
current configuration:
Configurations
1 - Data Port Configuration
2 - Voice/Fax Channel(s) Configuration
3 - Composite Link Configuration
4 - Factory Default Configuration Options
5 - Configure Remote Unit
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
For the main office and the home office units, let’s use the default data port configuration. If your
specific configuration requires that the data port be set up differently, select the option and
choose the new parameter.
From the Configurations menu, select option 2, Voice/Fax Channel(s) Configuration, to configure
the voice/fax channels. For the main office, set up the local interface type (option 6) for an FXO
connection. For the remote interface type (option 11), accept the default FXS connection. For the
other selections, accept the defaults .
Voice/Fax Channel 1 Configuration
1 - Destination Channel : 1
2 - Digitizing Rate : 9600
3 - Output Level Atten. : 12
4 - Input Level Gain : 03
5 - Silence Suppression : Off
6 - Local Interface Type : FXS
7 - Ground/Loop Start (FXS) : Loop
8 - 2 or 4 Wire (E&M) : N/A
9 - Dialtone/Wink (E&M) : N/A
10 - Wink Timer (E&M) : N/A
11 - Remote Interface Type : FXS
12 - Ground/Loop Start (FXS) : Loop
13 - 2 or 4 Wire (E&M) : N/A
14 - Dialtone/Wink (E&M) : N/A
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _