Filter
Top Products
60
DataTalker Owner’s Manual
5.3 V.35 Shunt
Table 5-2. V.35 Shunt Procedure
Step Procedure
1 Desktop version: Unplug the power supply from the back of the unit.
Rack version: Remove the unit from the RackTalker rack. Go to step 4.
2 Desktop version only: Turn the unit upside down and remove the two cabinet mounting
screws from the middle of the cabinet.
Cabinet
Mounting
Screws (2)
COMPOSITE
LINK
STATUS
VOICE /
FAX 1
DATA/
COMMAND
ORIG
101 MDM / TA
RXT FCR RD TM V35 EXT MDMDSU
CD RCV XMT CTS 56 RTS NS OOS
28.8 OHDBUP
TA
DTR
2B
COMXMT RCV FC FXS FXOE&M FAX XMT RCV XSG RSG
VOICE /
FAX 2
RSGXSGRCVXMTFA XE&MFXOFXS
Data / Voice / Fax Concentrator
Figure 5-11. Cabinet Mounting Screws
3 Desktop version only : Turn the cabinet right-side up, tilt the back down slightly, and the base
unit will slide out of the cabinet.
4 Desktop and rack versions: Place the unit with the LEDs facing you.
5 Pry the shunt out of the RS232 socket and insert it into the V.35 socket. Rack version: Go to
step 8.
1 2 3 4 5 6
RS-232
Shunt
V.35
Shunt
Figure 5-12. V.35 Shunt Location (Desktop Version)
6 Desktop version only: Slide the base back into the cabinet with the LEDs toward the front and
the rear grounding tabs pressing against the side of the cabinet.
7 Desktop version only: Turn the unit upside down and replace the two cabinet mounting
screws.
8 Desktop version: Turn the unit right-side up and reconnect the power supply.
Rack version: Slide the unit into the RackTalker card guides and, after ensuring that the
DataTalker is fully seated, fasten the retaining screws.