Filter
Top Products
49
Chapter 4 - Unpacking and Configuration
6 Apply power to the terminal or PC. Run your PC communications software in terminal mode.
Press the ENTER key twice to establish communications with the DataTalker; the Main Menu
then appears:
Main Menu
1 - Configurations
2 - Statistics
3 - Reset Options
4 - Diagnostics
5 - Exit Command Mode
6 - QUICK SETUP
Selection : _
7 To configure the DataTalker, enter number 1 and press ENTER. The Configurations menu
appears:
Configurations
1 - Data Port Configuration
2 - Voice/Fax Channel(s) Configuration
3 - Composite Link Configuration
4 - Factory Default Configuration Options
5 - Configure Remote Unit
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
8 If the data channel is async and the channel speed is 19.2K bps, you can use the data port
configuration defaults to start. Proceed to the voice/fax channel configuration (step 11).
If the data channel speed is higher or lower than 19.2K bps, then you must change the data
port configuration. Enter 1 and press ENTER to go to the Data Port Configuration menu.
Enter 2 and press ENTER to change the speed.
Data Port Configuration
1 - Async/Sync: Async
2 - Speed: 19200
3 - Word Length: 8
4 - Stop Bits: 1
5 - Parity: None
6 - Flow Control: CTS
7 - Enq/Ack Flow Control: Off
8 - Echo: Off
9 - Pacing: Off
10 - EIA Pass Through: Off
11 - Pass Xon: Off
S - Store All Configurations
M - Main Menu
P - Previous Menu
Selection : _
If you are connecting the data channel to a synchronous device, then you must change the
data port configuration. Enter 1 and press ENTER to go to the Data Port Configuration menu.
Only the first three options have to be considered for a synchronous device.