Filter
Top Products
Routing Commands
318
ProSafe M4100 and M7100 Managed Switches
show ip rip interface
This command displays information related to a particular RIP interface.
Format show ip rip interface {<slot/port> | vlan <1-4093>}
Modes
• Privileged EXEC
• User EXEC
Interface
IP Address
Send Version
Receive Version
RIP Admin
Mode
Link State
Authentication
Type
Default Metric
The following information will be invalid if the link state is down.
Bad Packets
Received
Bad Routes
Received
Updates Sent
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of
various types of ICMP messages.
RIP Mode
The administrative mode of router RIP operation (enabled or disabled).
Link State
The mode of the interface (up or down).
Term Definition
Valid slot and port number separated by forward slashes. This is a configured value.
The IP source address used by the specified RIP interface. This is a configured value.
The RIP version(s) used when sending updates on the specified interface. The types are
none, RIP-1, RIP-1c, RIP-2.
This is a configured value.
The RIP version(s) allowed when receiving updates from the specified interface. The
types are none, RIP-1, RIP-2, or Both
This is a configured value.
RIP administrative mode of router RIP operation; enable activates, disable deactivates it.
This is a configured value.
Indicates whether the RIP interface is up or down. This is a configured value.
The RIP Authentication Type for the specified interface. The types are none, simple, and
encrypt.
This is a configured value.
A number which represents the metric used for default routes in RIP updates originated
on the specified interface. This is a configured value.
Term Definition
The number of RIP response packets received by the RIP process which were
subsequently discarded for any reason.
The number of routes contained in valid RIP packets that were ignored for any reason.
The number of triggered RIP updates sent on this interface.
Term Definition