Filter
Top Products
IPv6 Multicast Commands
439
ProSafe M4100 and M7100 Managed Switches
show ipv6 mld-proxy
Use this command to display a summary of the host interface status parameters.
Format show ipv6 mld-proxy
Mode
• Privileged EXEC
• User EXEC
The command displays the following parameters only when you enable MLD-Proxy.
Interface Index
Admin Mode
Operational Mode
Version
Number of Multicast Groups
Unsolicited Report Interval
Querier IP Address on Proxy
Interface
Older Version 1 Querier
Timeout
Proxy Start Frequency
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 mld-proxy
Interface Index............................................. 0/3
Admin Mode................................................ Enable
Operational Mode......................................... Enable
Version......................................................... 3
Num of Multicast Groups............................. 0
Unsolicited Report Interval.......................... 1
Querier IP Address on Proxy Interface........ fe80::1:2:5
Older Version 1 Querier Timeout................ 00:00:00
Proxy Start Frequency.................................
Field Description
The interface number of the MLD-Proxy.
Indicates whether MLD-Proxy is enabled or disabled. This is a configured
value.
Indicates whether MLD-Proxy is operationally enabled or disabled. This is a
status parameter
.
The present MLD host version that is operational on the proxy interface.
The number of multicast groups that are associated with the MLD-Proxy
interface.
The time interval at which the MLD-Proxy interface sends unsolicited group
membership report.
The IP address of the Querier, if any, in the network attached to the
upstream interface (MLD-Proxy interface).
The interval used to timeout the older version 1 queriers.
The number of times the MLD-Proxy has been stopped and started.