Filter
Top Products
Green Ethernet Commands
737
ProSafe M4100 and M7100 Managed Switches
clear green-mode statistics
This command to clears the following for a specified <slot/port>, or for all ports:
• EEE LPI event count, and LPI duration
• EEE LPI history table entries
• Cumulative Power savings estimates
Format clear green-mode statistics {<slot/port> | all}
Mode
Example
(switch) #clear green-mode statistics 0/1
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
(switch) #clear green-mode statistics all
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
show green-mode <slot/port>
This command displays green mode configuration and operational status of a port. This
command can also display the per port configuration and operational status of the
green-mode. The status is shown only for the modes supported on the switch.
Format show green-mode <slot/port>
Mode
Privileged Exec
Privileged Exec
Table 57. Green-Mode status terms
Term Definition
Energy-detect admin
mode
Energy-detect mode is enabled or disabled.
Energy-detect
operational status
Energy detect mode is currently active or inactive. The energy detect mode might be
administratively enabled, but the operational status might be inactive. The reasons
for the same are described below.
Reason for Energy-detect
current operational status
The energy detect mode might be administratively enabled, but the operational
status might be inactive. The reasons for the same are:
- Port is currently operating in the fiber mode
- Link is up.
- Admin Mode Disabled
- Interface Not Attached
If the energy-detect operational status is active, the reason field displays
No energy Detected