Filter
Top Products
Quality of Service (QoS) Commands
459
ProSafe M4100 and M7100 Managed Switches
match protocol
This command adds to the specified class definition a match condition based on the value of
the IP Protocol field in a packet using a single keyword notation or a numeric value notation.
To specify the match condition using a single keyword notation, the value for
<protocol-name> is one of the supported protocol name keywords. The currently
supported values are: icmp, igmp, ip, tcp, udp. A value of ip matches all protocol number
values.
To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
Note: This command does not validate the protocol number value against
the current list defined by IANA.
match source-address mac
This command adds to the specified class definition a match condition based on the source
MAC address of a packet. The <address> parameter is any layer 2 MAC address formatted
as six, two-digit hexadecimal numbers separated by colons (for example, 00:11:22:dd:ee:ff).
The <macmask> parameter is a layer 2 MAC address bit mask, which might not be
contiguous, and is formatted as six, two-digit hexadecimal numbers separated by colons (for
example, ff:07:23:ff:fe:dc).
Default
Format match source-address mac <address> <macmask>
Mode
match srcip
This command adds to the specified class definition a match condition based on the source
IP address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask>
Format match ip tos <tosbits> <tosmask>
Mode
Class-Map Config
Default
none
Format match protocol {<protocol-name> | <0-255>}
Mode
Class-Map Config
Ipv6-Class-Map Config
none
Class-Map Config
Ipv6-Class-Map Config