Filter
Top Products
Quality of Service (QoS) Commands
480
ProSafe M4100 and M7100 Managed Switches
If an IP ACL by this name exists, this command enters IPv4-Access_List config mode to allow
updating the existing IP ACL.
Note: The CLI mode changes to IPv4-Access-List Config mode when you
successfully execute this command.
no ip access-list
This command deletes the IP ACL identified by <name> from the system.
Format no ip access-list <name>
Mode
ip access-list rename
This command changes the name of an IP access control list (ACL). The <name> parameter
is the names of an existing IP ACL. The <newname> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the IP access list.
This command fails is an IP ACL by the name <newname> exists.
Format ip access-list rename <name> <newname>
Mode
{deny | permit} (IP ACL)
This command creates a new rule for the current IP access list. Each rule is appended to the
list of configured rules for the list.
Note: The “no” form of this command is not supported, since the rules
within an IP ACL cannot be deleted individually. Rather, the entire IP
ACL must be deleted and respecified.
Note: An implicit “deny all” IP rule always terminates the access list.
Format ip access-list <name>
Mode
Global Config
Global Config
Global Config