Filter
Top Products
9-2 Administration Guide
WAN Configuration
To configure your Wide Area Network (WAN) connection, navigate to the WAN Configuration screen from the Main
Menu and select WAN Configuration, then WAN (Wide Area Network) Setup.
The DSL Line Configuration screen appears.
Each access concentrator (DSLAM) has a different set of defaults and other parameters.
Your service provider should supply you with the appropriate information about the type and capabilities of the
access concentrator equipment they use.
■ Select Regional Setting and from the pop-up menu select either Annex A or Annex B. North American users
select Annex A; non-North American users select Annex B.
■ Select Clock Source and from the pop-up menu select either Network (the default) or Internal.
■ Select Cell Format and from the pop-up menu select either Scrambled (the default) or Unscrambled. This
setting must match the format used by your service provider. Scrambled is the most common, so you
probably do not need to change it unless your provider specifically tells you to do so.
■ Select Unused Cell Format and from the pop-up menu select either Idle (the default) or Empty. This setting
must match the format used by your service provider. Idle is the most common, so you probably do not
Main
Menu
WAN
Configuration
WAN
Setup
DSL Line Configuration
Regional Setting... Annex A
Clock Source... Network
Cell Format... Scrambled
Unused Cell Format... Idle
Data Link Encapsulation... RFC1483
RFC1483 Mode... Bridged 1483
PPP over Ethernet (PPPoE): Off
Display/Change Circuit...
Add Circuit...
Delete Circuit...