Filter
Top Products
268 Configuring system settings
/cfg/sys/host <host ID>
followed by:
to delete the Nortel SNAS from the cluster
configuration (/cfg/sys/host #/delete).
Viewing host information
To view the host number and IP address for each Nortel SNAS device in
the cluster, use the /cfg/sys/host <host ID> /cur command.
Configuring host interfaces
The default IP interface on the Nortel SNAS host is Interface 1. You can
create additional interfaces and specify the ports to be assigned to each
interface. If you assign more than one port to an interface, you can choose
whether the ports will operate in failover or trunking mode.
You can create a maximum of four interfaces on each Nortel SNAS host.
To configure an IP interface and the assignment of physical ports on a
particular Nortel SNAS host, use the following command:
/cfg/sys/host <host ID> /interface <interface ID>
where interface ID is an integer in the range 1 to 252 that uniquely
identifies the interface on the Nortel SNAS host. To configure a
new interface, enter an unused interface ID number. To change the
configuration of an existing interface, enter the applicable interface ID
number.
The Host Interface menu appears.
The Host Interface menu includes the following options:
/cfg/sys/host #/interface <interface ID>
followed by:
ip <IPaddr>
Sets the network address for the interface.
(For Interface 1, the network address is the
RIP.)
netmask <mask>
Sets the subnet mask for the interface.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.