Filter
Top Products
272 Configuring system settings
where port is an integer in the range 1 to 4 indicating the port number
of the physical port on the Nortel SNAS. The port number is the number
identifying the port on the back of the Nortel SNAS.
The Host Port menu appears.
The Host Port menu includes the following options:
/cfg/sys/host #/port <port>
followed by:
autoneg on|off
Specifies the Ethernet auto-negotiation setting for the
host and NIC port. The options are:
•
on—the port is set to auto-negotiate speed and
mode. This is the recommended setting.
• off—speed and mode are fixed at a specified
setting.
The default is on.
When auto-negotiation is on, ensure that the
device to which the port is connected is also set to
auto-negotiate.
speed <speed> Sets the speed for the host and NIC port when
auto-negotiation is set to off.
•
speed—the port speed in megabits per second.
The options are 10|100|1000.
mode full|half
Sets the duplex mode for the host and NIC port when
auto-negotiation is set to off. The options are full
and half.
The default duplex mode is full.
Managing interface ports
To view and manage the ports assigned to an interface, use the following
command:
/cfg/sys/host #/interface <interface ID> /ports
where
interface ID is an integer in the range 1 to 252 that
uniquely identifies the interface on the Nortel
SNAS host.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.