Filter
Top Products
Configuring the domain 87
If you do not want to add a network access devices at this time,
press Enter to accept the default value (no). Go to step 12.
11 To add a network access devices, enter the required information
when prompted. For more information, see “Using the quick
switch setup wizard” (page 60).
Do you want to configure a switch? (yes/no) [no]: yes
Enter the type of the switch (ERS8300/ERS5500)
[ERS8300]: IP address of Switch:
NSNA communication port[5000]:
Red vlan id of Switch:
To continue, go to step 12.
12 Specify the action to be performed when an SRS rule check fails.
The options are:
•
restricted—the session remains intact, but access is
restricted in accordance with the rights specified in the
access rules for the group
•
teardown—the SSL session is torn down
The default is restricted.
In the event that the Nortel health Agent checks fails
on a client, the session can be teardown, or left in
restricted mode with limited access.
Which action do you want to use for Health Agent check
failure? (teardown/restricted) [restricted]:
13 Specify whether you want to create a test local user (nha) in the
default nhauser group.
Do you want to create a test local user? (yes/no)
[yes]:
If you do want to create a test user, press Enter to accept the
default value (yes). The wizard will create a test user named
nha, with password nha, in the default nhauser group.
If you do not want to create a test user, enter no.
14 Specify whether you want to create a test user for system
authentication.
Do you want to create a test user for system
authentication? (yes/no) [yes]:
15 Wait while the wizard completes processing to create the
domain, then enter Apply to activate the changes.
The wizard assigns the following default VLAN IDs:
• Green VLAN = VLAN ID 110
• Yellow VLAN = VLAN ID 120
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.