Filter
Top Products
392 Configuration example
Figure 31
After all DHCP scopes have been created
--End--
Configure the network core router
There are no special requirements for the core router in a Nortel SNAS
network. Refer to the regular documentation for the type of router used
in your network.
Step Action
1 Create the Red, Yellow, Green, VoIP, and Nortel SNAS
management VLANs.
2 Assign the VLAN port members.
Since the edge switches in this example are operating in Layer
2 mode, enable 802.1q tagging on the uplink ports to enable
them to participate in multiple VLANs, then add the ports to the
applicable VLANs.
3 Create IP interfaces for the VLANs.
4 Since the edge switches are operating in Layer 2 mode,
configure DHCP relay agents for the Red, Yellow, Green, and
VoIP VLANs.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.