Filter
Top Products
Configuring the cluster 269
/cfg/sys/host #/interface <interface ID>
followed by:
gateway <IPaddr> Sets the default gateway address for the
interface. The default gateway is the IP
address of the interface on the core router that
will be used for management traffic (such as
requests to private authentication servers and
DNS servers).
The default gateway will be used only for
Nortel SNAS domains that point to this
interface (/cfg/doamin #/adv/interface.
If no domain points to this interface, the
specified gateway will be ignored.
routes
Accesses the Host Routes menu, in order
to manage static routes for the Nortel SNAS
when there is more than one interface (see
“Configuring static routes” (page 270)).
vlanid <tag>
Specifies the VLAN tag if packets received by
the interface are tagged with a specific VLAN
tag ID.
mode failover|trunking
Specifies the mode of operation for the port
numbers assigned to this interface. The
options are:
• failover—only one link is active at any
given time. If the port with an active link
fails, the active link is immediately switched
over to one of the other ports configured
for the interface. When you select failover
mode, you also have the option of
specifying a primary port (see /cfg/sys/
host #/interface #/primary).
• trunking—active links are sustained on
all configured ports simultaneously, in order
to increase network throughput.
The default is failover.
ports
Accesses the Interface Ports menu, in
order to manage ports for the interface (see
“Managing interface ports” (page 272)).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.