Filter
Top Products
98 Configuring the domain
To configure the portal server used in the domain, use the following
command:
/cfg/domain #/server
The Server 1001 menu appears.
The Server 1001 menu includes the following options:
Table 6
Configuring SSL server
/cfg/domain #/server
followed by:
port <port> Specifies the port to which the portal server listens
for HTTPS communications.
• port is an integer in the range 1–65534 that
indicates the TCP port number. The default is
443.
interface <interface
ID>
Specifies the backend interface used by the server.
• interface ID is an integer that indicates the
interface number. The default is 0.
dnsname <name>
Assigns a DNS name to the portal IP address.
•
name is the fully qualified domain name (FQDN)
of the pVIP (for example, nsnas.example.com).
Generally, you need to specify a DNS name only
if your corporate DNS server is unable to perform
reverse lookups of the portal IP address.
When you press Enter after specifying the DNS
name, the system performs a check against the
DNS server included in the system configuration
(see /cfg/sys/dns) to verify that:
• the FQDN is registered in DNS
• the resolved IP address corresponds to the
pVIP
trace
Accesses the Trace menu, in order to capture
and analyze SSL and TCP traffic between clients
and the portal server. For more information, see
“Tracing SSL traffic” (page 99).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.