Nortel Networks 2000 Switch User Manual


 
Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 34 Document #: LTRT-72504
Figure 3-8: DC Terminal Block Screw Connector
When using a DC terminal block crimp connector, take these 3 steps:
1. Remove the DC adaptor (screw connection type) that is attached to the Mediant 2000 rear
panel.
2. Connect the two insulated wires to the correct DC power supply. Ensure that the connections
to the DC power supply maintain the correct polarity (refer to Figure
3-9).
3. Insert the terminal block into the DC inlet located on the Mediant 2000.
Figure
3-9: DC Terminal Block Crimp Connector
2 screws for
connecting the
crimp terminal
block to the
Mediant 2000 rear
panel