Nortel Networks 2000 Switch User Manual


 
Mediant 2000 SIP User’s Manual 5. Web Management
Version 4.4 47 July 2005
Table 5-1: Number Manipulation Parameters
Parameter Description
Prefix / Suffix to add
Prefix - Enter the number / string you want to add to the front of the phone
number. For example, if you enter 9 and the phone number is 1234, the new
number is 91234.
Suffix - Enter the number / string (in brackets) you want to add to the end of the
phone number. For example, if you enter (00) and the phone number is 1234, the
new number is 123400.
Note: You can enter a prefix and a suffix in the same field (e.g., 9(00)).
Number of digits to leave Enter the number of digits that you want to leave from the right.
Note: The manipulation rules are executed in the following order:
1. Num of stripped digits
2. Number of digits to leave
3. Prefix / suffix to add
Figure 5-4 on the previous page exemplifies the use of these manipulation rules in the ‘Source Phone Number
Manipulation Table for TelIP Calls’:
When destination number equals 035000 and source number equals 20155, the source number is changed to
97220155.
When source number equals 1001876, it is changed to 587623.
Source number 1234510012001 is changed to 20018.
Source number 3122 is changed to 2312.
NPI Select the Number Plan assigned to this entry.
You can select Unknown [0], Private [9] or E.164 Public [1].
The default is Unknown.
For a detailed list of the available NPI/TON values, refer to Section 5.8.3.2 on page
48.
TON Select the Number Type assigned to this entry.
If you selected Unknown as the Number Plan, you can select Unknown [0].
If you selected Private as the Number Plan, you can select Unknown [0], Level 2
Regional [1], Level 1 Regional [2], PSTN Specific [3] or Level 0 Regional (Local)
[4].
If you selected E.164 Public as the Number Plan, you can select Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4] or Abbreviated
[6].
The default is Unknown.
Presentation Select ‘Allowed’ to send Caller ID information when a call is made using these
destination / source prefixes.
Select ‘Restricted’ if you want to restrict Caller ID information for these prefixes.
5.8.3.1 Dialing Plan Notation
The dialing plan notation applies, in addition to the four Manipulation tables, also to TelIP
Routing table and to IPTrunk Group Routing table.
When entering a number in the destination and source ‘Prefix’ columns, you can create an entry
that represents multiple numbers using the following notation:
[n-m] represents a range of numbers
[n,m] represents multiple numbers. Note that this notation only supports single digit numbers.
x represents any single digit
# (that terminates the number) represents the end of a number
A single asterisk (*) represents any number
For example:
[5551200-5551300]# represents all numbers from 5551200 to 5551300