Filter
Top Products
Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 62 Document #: LTRT-72504
5.9 Advanced Configuration
Use this menu to set the gateway’s advanced configuration parameters (for advanced users
only).
5.9.1 Configuring the Network Settings
From the Network Settings page you can define:
• IP settings.
• NTP settings.
• Syslog settings.
• SNMP settings.
• RTP settings.
• Ethernet Ports Information (read-only).
To configure the Network Settings parameters, take these 4 steps:
1. Open the ‘Network Settings’ screen (Advanced Configuration menu > Network Settings);
the ‘Network Settings’ screen is displayed.
2. Configure the Network Settings parameters.
3. Click the Submit button to save your changes.
4. To save the changes so they are available after a power fail, refer to Section
5.12 on page
84.
Figure
5-14: Network Settings Screen
Note that the default RTP Base UDP Port is 6000.