Filter
Top Products
Page 158 of 332 Chapter 12 — Installing the circuit cards
553-3021-209 Standard 3.00 April 2000
Table 29
NT8D15 E&M Trunk card option settings
2 Insert the card in its assigned slot.
—————————— End of Procedure ——————————
NT8D02 Digital Line Card
The NTDK16 48-port Digital Line Card is functionally equivalent to three
NT8DO2 Digital Line Cards. However, the Option 11C Mini system also
supports the NT8D02 Digital Line Card.
You can install this circuit card in slots 1 to 3 of the Main Chassis or slots 7
to 10 of the Chassis Expander.
Procedure 13
NT8D02 circuit card installation
1 Insert the circuit card in slots 1 to 3 of the Main Chassis or in slots 7 to
10 of the Chassis Expander.
—————————— End of Procedure ——————————
NTAK02 SDI/DCH card
The NTDK97 MSC card includes the functionality of the NTAK02 card.
However, if you require additional resources, you can use the NTAK02 card
with the NTDK97 card. Before inserting the NTAK02 SDI/DCH card into its
slot, you must set the switches and attach the jumper plugs.
Note:
Install this circuit card in the Main Chassis only.
The NTAK02 SDI/DCH switches allow you to configure the four SDI ports
as a combination of the following:
•SDI
Mode of operation J2 J9
4W — Type 1 ON connect pins 2 - 3
4W — Type 2 ON connect pins 2 - 3
2W — Type 1 ON connect pins 2 - 3
Paging trunk ON connect pins 2 - 3