Filter
Top Products
Page 276 of 332 Chapter 18 — Connecting the trunks
553-3021-209 Standard 3.00 April 2000
8 Terminate the sequence by hanging up the telephone receiver.
OR
Repeat the sequence by going through the steps again.
When you enter “#” when the procedure repeats, you accept the next
TN and are prompted for the model type.
When you enter “#” again, you accept the previously accepted model.
Note:
The model selected during the first trunk activation sequence is
the default model for all subsequent trunks. This is the case until you
hang up the telephone or manually enter a new trunk model number.
—————————— End of Procedure ——————————
Activating a selected model trunk
Due to the automatic 30 second time-out on the administration menu, prepare
the data that you want to input before you begin. To determine the
corresponding TNs and trunks, check the location of trunk cards in the chassis
or use LD 32.
Procedure 42
Activating a selected model trunk
1 Lift the handset of the administration telephone.
2 Enter the administration Flexible Feature Code to access the
administration menu.
3 Enter the default administration telephone password.
You hear special dial tone and the prompt “TASK?” appears on the top
line of the character display. The second line of the character display
reads “1 ADD TRUNK”.
4 Select “1 ADD TRUNK” by entering the number “1”.
The prompt
“ROUTE ACCESS?” appears.
5 Enter the access code of the configured trunk route to which you
want to add the trunk and press the pound key (#).
The prompt
“TN?” asks you to enter a TN from one of the installed trunk cards. If
you do not enter a valid route number, “TN?” does not appear and the
screen remains the same. If the card does not match the route, the
prompt “ROUTE ACCESS?” appears again, and you hear overflow
tone.