Filter
Top Products
Page 330 of 332 Appendix B – Changing preprogrammed data
553-3021-209 Standard 3.00 April 2000
Modifying model trunks
If you want to modify a trunk, load LD 14 and enter the following commands
on the TTY:
LD 14
REQ CHG
TYPE aaa M “aaa” = the type of trunk that you are
modifying
MODL YYY “YYY” = the model number of the trunk
that you are modifying (between 1 - 127)
Removing model trunks
To remove a trunk model from the system, load LD 14 and respond to the
prompts as follows:
LD 14
REQ OUT
TYPE XXX M “XXX” = the trunk type of the model that
you are removing (Examples: COT, TIE,
DID, FEX, WAT, etc.)
CUST 0
MODL YYY “YYY” = the model number associated
with the trunk type you are removing
(Valid range is 1-127).
Printing model information
To print information about model trunks, load LD 20 and enter the following
commands on the TTY:
LD 20
REQ PRT
TYPE TTTT M “TTTT” = the trunk type
MODL YYY “YYY” = the model number. If you want to print all of the
models for this trunk type, leave this value blank.