Filter
Top Products
Chapter 17 — Connecting the telephones Page 251 of 332
Option 11C Mini Planning and Installation Guide
3 Enter the customized extension number and press the pound
key.
You hear a short high-pitched beep which lasts four seconds, followed
by silence (relocation tone).
If the extension number is already in use by another telephone, you
hear special dial tone again.
If the extension number is not available for use, you hear a fast,
high-pitched broken tone (overflow tone), and you must repeat this
step.
4 Hang up the telephone handset.
After approximately 10 seconds, the telephone is configured.
Note:
If other keys require secondary extension numbers, you are
prompted until you enter all of the required extension numbers for the
model. These extension numbers cannot be defaulted. You are
prompted for each additional extension number with three beeps
followed by continuous dial tone (special dial tone). When you are
programming an extension number, the lamp associated with that
number on the telephone is lit.
—————————— End of Procedure ——————————
Activating terminals on a DSL
Refer to the
ISDN BRI Administration and Maintenance Guide
(553-3011-311)
for information about activating and initializing the terminals
that can be connected to a terminal DSL.