Filter
Top Products
Appendix B: Dialing Translation 63
P0886629 Issue 1.0 FAX Set Up and Operation Guide
Reviewing the entries in the Dialing Translation Table
You can review or check the entries in your Dialing Translation Table at anytime.
To review your Dialing Translation Table entries:
1. Press
.
2. Enter the System Coordinator Mailbox number and
password and press OK
.
3. Press
.
4. Press TABLE
. If Centrex is installed on your Norstar
system, QUIT
is replaced by NEXT.
5. Press CHNG
.
6. Press NEXT
to view the next entry in the Dialing
Translation Table.
Note: The display shows 16 characters. If the total
number of Input and Output values equals
more than 16 digits a VIEW>
softkey will
appear on the left side of the display. After
you have pressed VIEW>
to view the digits
furthest to the right, the softkey changes to
<VIEW
. Press the <VIEW softkey to view the
digits on the left again. The inval*
outval* is an example of a Table entry.
The * character shown after a value
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after
every Input and Output value.
7. Continue pressing NEXT
to view all the entries in
the Dialing Translation Table.
8. Press to end this programming session.
Log:
QUIT RETRY
Admin
MBOX AA OTHR
Dialing
PARM QUIT
Dial table
ADD QUIT
inval* outval*
OTHR
inval* outval*
OTHR