Filter
Top Products
70 Appendix B: Dialing Translation
FAX Set Up and Operation Guide P0886629 Issue 1.0
Loading the Dialing Translation Table file onto the Norstar Voice Mail system
To load the Dialing Translation Table file onto the Norstar Voice Mail system you
must shut down Norstar Voice Mail and then reboot the system using the DOS
system disk you created. A Norstar two-line telephone is required to perform the
following steps.
To load the Dialing Translation Table file:
1. Press
.
2. Enter the default password
(ACCESS2) and press OK
.
3. Press NEXT
.
4. Press SHOW
.
5. Press GRACE
.
6. Press YES
.
Note: The Norstar Voice Mail system issues a
series of tones in descending pitch when the
shutdown is complete. Wait for the tones
before you unplug the NAM.
7. Unplug the AC power to the NAM.
8. Open the front cover of the NAM to access the
floppy disk drive.
9. Insert the DOS system disk you copied the Dialing
Translation Table file onto.
10. Plug in the NAM.
11. Wait until the light on the floppy disk drive goes out
and then unplug the NAM and remove the DOS
system disk.
12. Close the front cover of the NAM.
Password
RETRY
ACCESS Server
BACK ADMIN
System shutdwn
BACK NEXT
Shutdown type
QUIT NEXT
Shutdown Graceful
NO