Filter
Top Products
Appendix B: Dialing Translation 65
P0886629 Issue 1.0 FAX Set Up and Operation Guide
Changing an entry in the Dialing Translation Table
After a Dialing Translation Table has been built, you can change the Output value
of an entry at any time. To locate the entry that you wish to change, refer to
"
Reviewing the entries in the Dialing Translation Table" on page 63 or "Finding an
entry in the Dialing Translation Table" on page 64.
Note: You cannot change the Input value of an entry. The entry must be deleted
and a new entry must be created with new Input and Output values. Refer to
"
Deleting a Dialing Translation Table entry" on page 66.
To change an entry in the Dialing Translation Table:
1. Press
.
2. Enter the System Coordinator Mailbox number and
password and press OK
.
3. Press
.
4. Press TABLE
. If Centrex is installed on your Norstar
system, QUIT
is replaced by NEXT.
5. Press CHNG
.
6. Press OTHR
. inval* outval* is an example of a
Table entry. The * character shown after a value
signifies any digits in the telephone number
remaining to be dialed. Norstar Voice Mail
automatically adds the * character after every Input
and Output value.
7. Press CHNG
.
8. Enter the new Output value and press OK
.
9. Repeat steps 6 through 8 to change any other entries
in the Dialing Translation Table.
10. Press to end this programming session.
Log:
QUIT RETRY
Admin
MBOX AA OTHR
Dialing
PARM QUIT
Dial table
ADD QUIT
inval* outval*
NEXT
inval* outval*
DEL FIND
Out:
RETRY
inval* outval*
NEXT OTHR