Filter
Top Products
(Revised 2010-7-2) page 109 of 145
Show port statistics
Command Name
port show stats
Description
This command is used to get the port statistics of a given port for all
available counters.
Syntax
port show stats <port-no>
Parameters
port-no
Port number. (1 ~ 26).
Examples
N-TRON/Admin#[1]> port show stats 5
--------------------------------------------
COUNTER TYPE :[]
--------------------------------------------
COUNTER NAME COUNTER VALUE
--------------------------------------------
byteFrames 28072
64 byte Frames 272
64-127 byte Frames 24
128-255 byte Frames 43
256-511 byte Frames 43
512-1023 byte Frames 0
1024-1518 byte Frames 0
1519-1522 byte Frames 0
… … … …
NOTES
Check whether port-no is in the valid range. (1 ~ 26)
Get total number of good frames received
Command Name
port get totalgoodframes
Description
Gets the total number of good frames received on the switch.
Syntax
port get totalgoodframes
Parameters
None
Examples
eg.1
N-TRON/Admin#[1]> port get totalgoodframes
Total no of good frames: [12456]
NOTES
Get port speed
Command Name
port get speed
Description
Gets the port speed in megabits.
Syntax
port get speed <port-no>
Parameters
port-no
Port number. (1 ~ 26).
Examples
N-TRON/Admin#[1]> port get speed 4
port speed of port no [4] is : [10]
N-TRON/Admin#[2]> port get speed 5
port speed of port no [5] is : [100]
NOTES
Check whether port-no is in the valid range. (1 ~ 26)
Set Port Speed
Command Name
port set speed
Description
Sets the port speed of a given port.
Syntax
port set speed <port-no><speed>
Parameters
port-no
Port number. (1 ~ 26)
speed
Speed of the port. Speed must either 10, 100, 1000 megabits per sec.
Examples
N-TRON/Admin#[1]> port set speed 5 10
N-TRON/Admin#[2]> port set speed 9 100
NOTES
Get the port duplex mode
Command Name
port get duplexmode
Description
Gets the port Duplex mode (FULL_DUPLEX / HALF_DUPLEX) for a