(Revised 2010-7-2) page 111 of 145
N-TRON/Admin#[1]> port get autonego 6
Auto negotiation mode is : [enabled]
N-TRON/Admin#[2]> port get autonego 24
Auto negotiation mode is : [disabled]
Check whether port-no is in the valid range. (1 ~ 24)
Set Auto-negotiation State
Sets the auto negotiation mode of a given port to either enable or disable. If
the port auto negotiation mode is enabled, the switch can automatically
adjusts it speed and duplex mode to the incoming speed and duplexmode.
port set autonego <port-no><enable | disable>
port-no
port number (1 ~ 24)
enable | disable
Auto negotiation enable or disable
N-TRON/Admin#[1]> port set autonego 6 enable
Auto negotiation mode of port[6] is : [enabled]
N-TRON/Admin#[2]> port set autonego 24 disable
Auto negotiation mode of port[6] is : [disabled]
Check whether port-no is in the valid range. (1 ~ 24)
Set Priority State
Enables or Disables the Priority State on a per port basis.
port set prioritystate <enable | disable><port-no>
port-no
port number (1 ~ 26)
enable | disable
Priority State enable or disable
N-TRON/Admin#[1]> port set prioritystate enable 6
Check whether port-no is in the valid range. (1 ~ 26)
Set Flow Control
Enable or Disable flow control (typically refers to 100Base). When
enabled a pause frame will be sent to help control the flow.
port set flowcontrol <port-no><enable | disable>
port-no
port number (1 ~ 24)
enable | disable
Flow Control enable or disable
N-TRON/Admin#[1]> port set flowcontrol 6 enable
Check whether port-no is in the valid range. (1 ~ 24)
Set Name
Changes the name of the port. This change will only be visible in the CLI.
port set name <port-no><name>
port-no port number (1 ~ 26)
name A string that describes the port
N-TRON/Admin#[1]> port set name 6 waterplant
This will be reset if you change a slot configuration.
Set PVID
port set pvid <port-no><pvid-number>
port-no
port number (1 ~ 26)
