Filter
Top Products
(Revised 2010-7-2) page 28 of 145
Administration – SNMP
The SNMP tab under the administration category shows a list of IP Addresses that act as SNMP
Traps. The Get, Set, and Trap Community Names are also shown here.
By selecting the modify button you will be able to change any of the fields listed. This allows the
user to set an IP address for an SNMP Trap or change the Community Names. Systems that are listed as an
SNMP Trap will be sent basic networking changes made to the switch such as ports going down or being
linked. To restore a Trap to “Value Not Configured”, enter „0.0.0.0‟.