Filter
Top Products
(Revised 2010-7-2) page 114 of 145
Get STP Status
Command Name
port get STP Status
Description
Displays the Spanning Tree Protocol Status on a given port.
Syntax
port get stpstatus <port-no>
Parameters
port-no
port number (1 ~ 26)
Examples
N-TRON/Admin#[1]> port get stpstatus 6
Stp state of [6] port is : [Forward]
NOTES
STP states include: Listening, Learning, Blocking, & Forwarding
Get Back Pressure
Command Name
port get backpressure
Description
Displays the backpressure information on a given port number (enabled or
disabled).
Syntax
port get backpressure <port-no>
Parameters
port-no
port number (1 ~ 24)
Examples
N-TRON/Admin#[1]> port get backpressure 6
Back Pressure is DISABLED
NOTES
Check whether port-no is in the valid range. (1 ~ 24)
Get PVID
Command Name
port get pvid
Description
Displays a given port‟s VLAN-ID.
Syntax
port get pvid <port-no>
Parameters
port-no
port number (1 ~ 26)
Examples
N-TRON/Admin#[1]> port get pvid 6
PVID of port 6 is 4.
NOTES
Check whether port-no is in the valid range. (1 ~ 26)
Clear Counters
Command Name
port clear counters
Description
Clears all the numbers in the counters for a given port. These are counters
for RX bytes and TX bytes and so on.
Syntax
port clear counters <port-no>
Parameters
port-no
port number (1 ~ 24)
Examples
N-TRON/Admin#[1]> port clear counters 6
Counters of Port[6] are : [cleared]
NOTES
This will clear all data in the port specific counters. This data cannot be
recovered after this step.
Clear Intruder Log
Command Name
port clear intruderlog
Description
This command will clear all intruders out of the intruder log.
Syntax
port clear intruderlog
Parameters
None
Examples
N-TRON/Admin#[1]> port clear intruderlog
NOTES
This will clear all data from the intruder log. This data can not be
recovered after this step.