Filter
Top Products
9. Option
77
9OptionMulti - Units
9.1 Canceling the handset
registration
If you no longer need to use the handset or if you
need to register the handset to a different base
unit of the same model, it may be necessary to
cancel the registration.
Only one handset can be canceled at a time near
the base unit.
Make sure the handset and the base unit are
not being used.
L Keep the front cover page open for button
locations.
1 Press {CONF/FUNCTION}.
2 Scroll to “Initial setting” by pressing
{v} or {e}, and press {>}.
3 Scroll to “Registration” by pressing {v}
or {e}, and press {>}.
4 Scroll to “Deregistration” by pressing
{v} or {e}, and press {>}.
5 Press {3}{3}{5} (DEL.) to delete the
registration memory.
L If you make a mistake, press
{HOLD/CLEAR}, and enter {3}{3}{5}.
6 Press the right soft key ({ OK}).
L A beep will sound and the registration
memory will be erased on both the
handset and the base unit.
L “[-]” is shown on the top right of the
display.
L If 3 beeps sound, you entered a wrong
code. Try again from step 5.
Note:
L If you do not press a button for more than 3
minutes, the unit will return to the standby
mode.
L To register the handset to another base unit
of the same model, start from step 5 in the re-
registering the handset procedure on page
77, or see page 32.
L The handset will not work. To use it again,
registration will be required (page 32, 77).
9.2 Re-registering the
handset
If you want to re-register the handset to the base
unit or a different base unit of the same model,
you need to register it to that base unit. The
handset will be given a new extension number of
that base unit. Only one handset can be
registered at a time. Make sure the base unit
and the other handsets are not being used.
Registration must be completed within 1
minute.
L If you have canceled the handset registration
at the previous base unit (page 77), start from
step 5.
L Keep the front cover page open for button
locations.
1 Handset:
Press {CONF/FUNCTION}.
2 Scroll to “Initial setting” by pressing
{v} or {e}, and press {>}.
3 Scroll to “Registration” by pressing {v}
or {e}, and press {>}.
4 Press {>} at “HS registration”.
5 Base unit:
Press {MUTE}.
6 Handset:
1. Press the right soft key ({OK}).
2. Wait until a long beep sounds and the
display shows the registered number.
The registration will be complete.
L The registered number “[1]” to “[8]”
will be shown on the top right of the
display.
OK
OK
0519_FPG381.book Page 77 Monday, May 19, 2003 6:46 PM