Filter
Top Products
10 –
ENGLISH
Accessories
Check that all of the accessories shown below have been included with your projector.
Remote Control
[N2QAYB000076 × 1]
Batteries for Remote
Control (AA)
Power cord Drop-prevention bracket
For 240 V
[K2CG3YY00035 × 1]
For 120 V
[K2CH3YY00001 × 1]
Eye bolt
[TPAHE86 × 4]
Wire
[TTRA0143 × 4]
Caution when moving the projector
The projection lens is susceptible to vibrations and impacts. Be sure to always remove the lens during transport.
Cautions regarding setup
Be sure to observe the following precautions when installing the product.
Be sure to install the projection lens cover after installing the projection lens.
If this is not done, dust will collect inside the projector and problems with the projector will result.
Avoid installing the product in a place exposed to vibrations or impacts.
If the projector is installed in a place where vibrations are transmitted from a source of driving power and
others or mounted in a car, vibrations or impacts may be transmitted to the product to damage the internal
parts, causing failure. Install the product in a place free from vibrations and impacts.
Do not install the projector near high-voltage power lines or power sources.
The product may be exposed to interference if it is installed in the vicinity of high-voltage electrical power
lines or power sources.
Do not place the projector on a vinyl sheet or carpet.
If a vinyl sheet sucked up and blocks the air filter intake port, the internal temperature of the projector may
increase, which triggers the protection circuit, turning off the power.
Be sure to ask a specialized technician when to install the product to a
ceiling.
If the product is to be installed hanging from the ceiling, purchase an optional hanging attachment (for high
ceiling: Model No. ET-PKD100H) (for low ceiling: Model No. ET-PKD100S) and call a specialized technician for
installation.
Do not operate the projector over 2 700 m (8881.5´) above sea level. When
operating between 1 400 m (4605.3´) and 2 700 m (8881.5´) above sea
level, set the “ALTITUDE MODE”, described on page 76, to “ON”.
Otherwise the life of the product may be shortened.
When installing and using the projector at an angle that exceeds 30 from
the horizontal in the vertical direction, set “DIRECTION”, described on
page 76, to “VERTICAL”.
Before Using