Filter
Top Products
64 –
ENGLISH
How to use ADVANCED MENU (continued)
Press ENTER.2.
The “CLAMP POSITION” screen will be •
displayed.
CLAMP POSITION
POSITION
ADJUST
1
Press ◄► to adjust.3.
The value changes from 0 to 255.•
The optimal value for the clamp position •
adjustment
If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
If the dark areas are displayed in green:
The optimal value is the point where the green
areas become black and the crushing effect is
rectified.
Note
The clamp position can be adjusted only when the
•
RGB signal input is applied with RGB1 and RGB2 IN.
Edge blending adjustment
The built-in edge blending feature allows multiple
projector images to be seamlessly overlapped.
Press ▲▼ to select “EDGE 1.
BLENDING”.
CLAMP POSITION
EDGE BLENDING
FRAME DELAY
OFF
DEFAULT
Press ◄► to switch “EDGE 2.
BLENDING”.
The setting will change as follows each time •
◄► is pressed.
OFF ON USER
OFF:•
When the multi-screens are not going to be used.
ON:•
When the default linear blending ramps are
sufficient.
USER:•
When a user-defined blending ramp is required.
These ramps can be defined and uploaded to the
projector through the RS-232 port. Consult your
dealer for details.
Press ENTER.3.
The “EDGE BLENDING” screen will be •
displayed.
EDGE BLENDING
UPPER
START
ON
0
Press ▲▼ to specify the area to 4.
be adjusted.
To blend the top edge:• set “UPPER” to “ON”.
To blend he bottom edge:
•
set “LOWER” to “ON”.
To blend the left edge:• set “LEFT” to “ON”.
To blend the right edge:• set “RIGHT” to “ON”.
Press ◄► to toggle “ON” and 5.
“OFF”.
Press ◄► to adjust the overlap 6.
width and the starting point.
To display the adjustment
marker
Press ▲▼ to select “MARKER”.7.
RIGHT
MARKER
BRIGHT ADJUST
OFF
OFF
Press ◄► to select “ON”.8.
A marker for adjusting the overlap position •
appears. The optimal point is the position
where the red line of one frame overlaps the
green line of the other frame.
The blending widths of each projector must be
set to the same value. Optimal blending cannot
be achieved if the widths are different.
The optimal point is where
these lines overlap.
Green line
Red line
Press ▲▼ to select “BRIGHT 9.
ADJUST”.
RIGHT
MARKER
BRIGHT ADJUST
OFF
OFF