Filter
Top Products
96 –
ENGLISH
How to use network functions (continued)
E-mail setup page
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can
be sent to one or more preset e-mail addresses (maximum two addresses).
Click [Detailed set up], then [E-mail set up] to display the E-mail setup page.
Select “Enable” to use the E-mail function.
Enter the IP address or server name of the
E-mail server (SMTP). The DNS server must
be set if the server name is entered.
Enter the E-mail address of the projector.
(maximum 63 characters)
The user can modify the minimum time
interval of temperature warning mail. The
default value is 60 minutes. In this case, the
user cannot send another mail for 60 minutes
after sending previous temperature warning
mail even the set warning temperature is
reached again.
The user can enter the location of, for
example, the installed projector so that the
recipient may easily identify the originator of
the E-mail. (maximum 63 characters)
The user can modify the threshold
temperature for sending temperature warning
mail. If the temperature rises above the set
value, control sends temperature warning
mail.
Enter the E-mail address of your desired
recipient.
Select the conditions for sending E-mail.
MAIL CONTENTS:
Select “NORMAL” or “SIMPLE”.
ERROR:
an error is detected by self-diagnosis.
LAMP1 RUNTIME:
remaining lamp service time has reached the
value set in the field.
LAMP2 RUNTIME:
remaining lamp service time has reached the
value set in the field.
LAMP3 RUNTIME:
remaining lamp service time has reached the
value set in the field.
LAMP4 RUNTIME:
remaining lamp service time has reached the
value set in the field.
INPUT AIR TEMPERATURE:
intake air temperature has reached the value
set in the field.
OUTPUT AIR TEMPERATURE:
exhaust temperature has reached the value
set in the field.