Filter
Top Products
Getting Started
ENGLISH
– 7
Do not place the projector on top of surfaces which are unstable.
If the projector is placed on top of a surface which is sloped or unstable, it may fall down or tip over, •
and injury or damage could result.
Do not place the projector into water or let it become wet.
Failure to observe this may result in fire or electric shocks.•
Do not disassemble the lamp unit.
If the lamp section breaks, it may cause injury.•
Do not place liquid containers on top of the projector.
If water spills onto the projector or gets inside it, fire or electric shocks could result.•
If any water gets inside the projector, contact an Authorized Service Center. •
Do not insert any foreign objects into the projector.
Do not insert any metal objects or flammable objects into the projector or drop them onto the projector, •
as doing so can result in fire or electric shocks.
After removing the battery from remote control unit, keep it away from
the reach of children.
The battery can cause death by suffocation if swallowed.•
If the battery is swallowed, seek medical advice immediately.•
Do not allow the + and - terminals of the battery to come into contact
with metallic objects such as necklaces or hairpins.
Failure to observe this may cause the battery to leak, overheat, explode or catch fire.•
Store the battery in a plastic bag and keep it away from metallic objects.•
Insulate the battery using tape or similar before disposal.
If the battery comes into contact with metallic objects or other batteries, it may catch fire or explode.•
Replacement of the lamp unit should be carried out by a qualified
technician.
The lamp unit has high internal pressure. If improperly handled, failure might result.•
The lamp unit can easily become damaged if struck against hard objects or dropped, and injury or •
malfunctions may result.
When installing to a ceiling, be sure to use the accessory wire (install
in a different location to the ceiling mount bracket) and the eye bolts
as an extra preventative measure to stop the projector from falling
down.
If the projector is not secure enough, accidents may result.•
Do not place sets directly on top of each other.
If this is not observed, accidents may result.•
Do not use the projector while the projection lens cover is still
attached to the projection lens (sold separately).
If this is not observed, fire may occur.•
Do not look into the lens while the projector is being used.
Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and •
damage your eyes.
Do not place your skin into the light beam while the projector is being
used.
Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or •
damage your skin.