Filter
Top Products
Horizontal (right and left)
adjustment.
Press the
w button.
The image position moves to the
right.
Press the
q button.
The image position moves to the
left.
[DOT CLOCK]
(Only for still image computer (RGB) signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the following striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at
a minimum. You can adjust the dot lock of image.
Press 1) as to select [DOT CLOCK].
Press 2) qw or the <ENTER> button.
The [DOT CLOCK] individual adjustment screen is displayed. f
Press 3) qw to adjust the value.
The adjustment values are -32 to +32. f
Attention
Set it before adjusting [CLOCK PHASE]. f
[CLOCK PHASE]
(Only for computer (RGB) signals input)
You can adjust to achieve an optimal image when there is a ickering image or smeared outlines.
Press 1) as to select [CLOCK PHASE].
Press 2) qw or the <ENTER> button.
The [CLOCK PHASE] individual adjustment screen is displayed. f
Press 3) qw to adjust the value.
The adjustment values are -16 to +16. Adjust so that the amount of interference is at a minimum. f
Note
Certain signals may not be adjustable. f
Optimal value may not be achieved if the output from the input computer is unstable. f
To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is f
adjusted.
[CLOCK PHASE] cannot be adjusted when a digital signal is input. f
[OVER SCAN]
Use this function when characters or pictures are cropped near the periphery of the projected image.
Press 1) as to select [OVER SCAN].
Press 2) qw or the <ENTER> button.
The [OVER SCAN] individual adjustment screen is displayed. f
Press 3) qw to adjust the level.
The adjustment values are 0 to +3. f
Note
It is unavailable for still image signals, HDMI signals and [NETWORK/USB]. f
ENGLISH
-
65
Chapter 4 Settings - [POSITION] menu