Filter
Top Products
Press 3) as to select the [PROJECTOR ID].
Select one from [ALL], and [1] to [6]. f
[ALL]
Select when controlling projectors without specifying an ID number.
[1] - [6]
Select when specifying an ID number to control individual projector.
Press the <ENTER> button to set it.4)
[PROJECTOR ID] is set. f
Note
The ID number can be set to [ALL], or from [1] to [6]. f
To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector. f
When the ID number is set to [ALL], the projector will operate regardless of the ID number specied during remote control or f
computer control.
If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors
with other ID numbers.
Refer to “Setting the remote control ID numbers” ( f Æpage 29) for how to set the ID number on the remote control.
[INITIAL START UP]
Set the method of start up when the power cord plugged into the AC outlet.
Press 1) as to select [INITIAL START UP].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[LAST MEMORY]
Starts in the condition that before disconnected the power cord or turn off the breaker.
[STANDBY]
Starts up in the standby mode.
[ON]
Starts the projection immediately.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the projection method if the screen display is upside down or inverted.
Press 1) as to select [PROJECTION METHOD].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[FRONT/DESK]
When installing the projector on the desk, etc. in front of the screen.
[FRONT/CEILING]
When installing the projector in front of the screen by using the Ceiling Mount Bracket for
Projectors (optional).
[REAR/DESK]
When installing the projector on the desk, etc. behind the screen (with a translucent screen).
[REAR/CEILING]
When installing the projector behind the screen (with a translucent screen) by using the Ceiling
Mount Bracket for Projectors (optional).
[HIGH ALTITUDE MODE]
Change the setting according to the altitude in which you use the projector.
Press 1) as to select [HIGH ALTITUDE MODE].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[OFF]
When using the projector in the elevation of below 1 400 m.
[HIGH1]
When using the projector in the elevation of above 1 400 m and below 2 000 m.
[HIGH2]
When using the projector in the elevation of above 2 000 m and below 2 700 m.
Note
It is set to [OFF] when using the projector in the elevation of below 1 400 m. It is set to [HIGH1] when using the projector in f
the elevation of above 1 400 m and below 2 000 m. It is set to [HIGH2] when using the projector in the elevation of above
2 000 m and below 2 700 m. Failure to do so may shorten the life of the internal parts and result in malfunctions.
Do not set the projector in the elevation of 2 700 m or above, otherwise it may shorten the life of the internal parts and result f
in malfunctions.
When it is set to [HIGH1] or [HIGH2], the fan noise becomes louder and fan speed increases. f
ENGLISH
-
75
Chapter 4 Settings - [PROJECTOR SETUP] menu