Filter
Top Products
149
Replacing the Lithium Battery
During the initial self test, when the power is turned “On”, the machine will evaluate the condition of the back up
battery. If the battery is weak or fully discharged, the following message will be shown on the display.
To replace the battery, follow the procedure below:
(see Note 1)
1
(1) Remove the Battery Holder.
(If the Battery Holder does not come out
easily, open the Printer Cover and try
again.)
CAUTION
!
Dispose of the Lithium Battery properly
and keep it away from small children.
2
(1) Remove the Battery from the Battery
Holder.
(2) Install the new Battery into the Battery
Holder with the ⊕ side facing upwards.
(Order No.: CR2032)
CAUTION
!
When replacing the battery make sure to
observe the polarity to avoid damage to
the machine.
3
(1) Re-install the Battery Holder.
4
If the clock is flashing on the LCD Display, follow the procedure on page 26 to reset the clock.
1. The service life of the battery is approximately 1 year when the machine is turned “Off”.
REPLACE BATTERY
INFO. CODE=026
Troubleshooting
8
Note: