Filter
Top Products
Operation
3-193170-A2-GB20-20 December 1996
Selecting the Number of Trap Managers
If
you intend to issue traps to an SNMP manager(s)
from this device, you must specify the number of SNMP
managers that are to receive the traps.
To specify the number of SNMP managers to receive
traps from this device,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key
. Use the scroll keys, if necessary
.
3. Press F1 to select Edit.
4.
Press the
key from the Edit screen to display
the SNMP selection.
5.
Select SNMP
.
F1
Edit:
User Alarm SNMP
F2
F3
6. Select Trap from the SNMP Config screen.
F1
SNMP Config:
Gen Trap
F2
F3
7. Select the number of SNMP managers to receive
traps (from 1 through 6) by using the appropriate
Function key
. Use the scroll keys, if necessary
.
F1
Num Trap Mgrs:1
Next 1 2
F2
F3
Configuring a Destination for SNMP Traps
A destination must be configured for each SNMP trap
manager specified. This configuration option is displayed
for the number of trap managers specified by the Number
of Trap Managers configuration option.
To configure an IP address for the SNMP trap
manager,
1. Press F3 to select Cnfig from the top-level menu
screen.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key
. Use the scroll keys, if necessary
.
3. Press F1 to select Edit.
4.
Press the
key from the Edit screen to display
the SNMP selection.
5.
Select SNMP
. (For screen displays, see the
previous section, Selecting the Number of T
rap
Managers.)
6. Select Trap from the SNMP Config screen.
7. Press F1 (Next) until the Trapn IP Address
configuration option appears.
8. Press F2 (Edit) to edit the IP address. Y
ou have the
option of using F3 (Clear) to reset the IP address
to the factory default 000.000.000.000. Refer to
the Setting the IP Address section on page 3-15 for
more information on setting an IP address.
9. Press F1 (Next) until the Trapn Destination
configuration appears, and select the destination
for the SNMP trap by using the appropriate
Function key
. Use the scroll keys, if necessary
.
F1
Trap
n
Dst:
Next None Com
F2
F3