Filter
Top Products
A. Configuration Options
A-12
May 2002 8700-A2-GB20-40
Copy Ports Options
You can copy the configuration options of one DSX-1 or G.703 interface, or DSL
loop to another using the Copy Ports screen. For Copy Ports options, refer to
Table A-6, Copy Port Options. To access the Copy Ports screen, follow this menu
selection sequence:
Main Menu
→
Configuration
→
Current Configuration
→
Copy Ports
Table A-6. Copy Port Options
From: Port
n
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8
Default Setting: 1
Controls the source of the configuration options.
1– 8 – The configuration of the selected port is copied.
To: Port
y
Possible Settings: 1, 2, 3, 4, 5, 6, 7, 8, All
Default Setting: 1
Controls the target of the configuration options.
1– 8 – The configuration of the selected port is replaced. If Perform Copy Then
Increment is selected, the port number is incremented by 1 after the copy.
All – The configurations of all ports are replaced by the configuration of the selected
From: Port.
NOTE: Peer IP Address and Circuit Identifier are
not
copied.
main/config/copy
Slot: 18 Model: 87xx
COPY PORTS
From: Port 1
To: Port 2
Perform Copy
Perform Copy Then Increment
--------------------------------------------------------------------------------
ESC for previous menu M
ainMenu Exit
S
ave