Filter
Top Products
2. Using the Asynchronous Terminal Interface
2-2
May 2002 8700-A2-GB20-40
Logging In to the Hotwire DSLAM
You can log in to the Hotwire DSLAM system using either a local
VT100-compatible terminal or a remote Telnet connection.
After you enter your user ID and password, the system displays the Hotwire
Chassis Main Menu. See your management card documentation for information
about selecting the unit from the card selection screen.
Initiating an ATI Session
The Main Menu screen is displayed unless a login ID and password is required or
the ATI is already in use.
If security is enabled on the termination unit and Telnet is used to access the unit
directly (you did not log in through the MCC), the system prompts you for a login
ID and password.
If you enter an invalid login ID and password three times, the Telnet session closes
or the terminal connection returns to an idle state. Refer to Chapter 6,
Security
.
If the ATI is already in use, the message
connection refused
is sent to a
terminal attempting Telnet access.
Login
Slot: 4
Model: 87xx
LOGIN
Login ID:
Enter Password:
--------------------------------------------------------------------------------
Ctrl-a to access these functions E
xit