Filter
Top Products
B. Standards Compliance for SNMP Traps
B-6
May 2002 8700-A2-GB20-40
The tests that affect the enterpriseTestStart and enterpriseTestStop traps and the
variable bindings depend on the interface. The specific tests and variable bindings
are described in the following table.
Interface
enterpriseTestStart/Stop
variable bindings Possible Cause
DSL Network ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopLLB(4) – Initiates a
Local Loopback.
– testLoopRLB(5) – Initiates a
Repeater Loopback.
– testSendMon511(6) – Initiates a
Send and Monitor 511 test.
– testSendLLBUp(7) – Initiates an
LLB Up message to the remote
unit.
– testSendLLBDown(8) – Initiates
an LLB Down message to the
remote unit.
enterpriseTest Start – Any one
of the following tests is active
on the interface:
– Line Loopback
– Repeater Loopback
– Remote Line Loopback
– Send and Monitor 511
enterpriseTest Stop – No tests
currently running on the
interface.
DSX-1 or
G.703
ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest(0) – Stops the test in
progress.
– testLoopDTLB(3) – Initiates a
DTE Loopback.
– testLoopPLB(1) – A
Telco-initiated Payload
Loopback is active on the
interface (DSX-1 only).
enterpriseTest Start – Any one
of the following tests is active
on the interface:
– DTE Loopback
– Telco Payload Loopback
(DSX-1 only)
enterpriseTest Stop – No tests
currently running on the
interface.