Filter
Top Products
DM500™ and DM550™ Series Digital Mailing System Operating Guide
SV61436 Rev. D 5-21
Timeouts:
Normal Preset
Timer
The normal preset timer option allows you to specify how much time you
want to allow the system to remain idle before it returns to the Normal Pre-
set settings (refer to De
fine Presets section in this chapter for more infor-
mation on Normal Presets).
You can set this timeout for 0 - 1440 minutes, in 1 minute increments. The
de
fault timeout is 30 minutes.
1. Press the Men
u key and select Set Up.
2. Select Bas
ic Settings and then Timeouts.
3. Select Normal
Preset Timer.
4. To set the timer, enter the number of minutes (0-1440) using the
numeric ke
yboard.
5. If you want the system to stay at the last settings used, select Never
reset
to Normal Preset.
6. Press the Enter key
.
Timeouts:
Feeding Timeout
Use this option to specify how much time to allow before the feeder stops
after the last envelope is processed.
You can set this timeout for 5 - 90 seconds, in 1 second increments. The
de
fault timeout is 5 seconds.
This reduces the wear on your machine a
nd acts as a safety measure if
you leave the machine unattended.
1. Press the Men
u key and select Set Up.
2. Select Bas
ic Settings and then Timeouts.
3. Select Fe
eding Timeout.
4. Enter the number of seconds (0 - 90) using the numeric keyboard, or
pre
ss the screen key corresponding to Turn Rollers off Immediately,
or Run Until Stop key is Pressed.
5. If you entered the number of seconds, press the Enter ke
y.
Timeouts:
Waiting for Env
This option allows you to specify how long the system will continue to feed
mail placed on the feed deck without having to press the Start key.
You can set this timeout for 0 - 90 seconds, in 1 second increments. The
de
fault timeout is 20 seconds.
1. Press the Men
u key and select Set Up.
2. Select Bas
ic Settings and then Timeouts.
3. Select W
aiting for Env.
4. Enter the number of seconds (0 - 90) using the numeric keyboard.
5. Press the Enter key
.