Filter
Top Products
10-7
10 • Maintenance
SV62214 Rev. A
2. Separate wick from metal holder, clean the wick in plain water,
and rinse thoroughly.
3. Place the wick back in the hold er.
4. Reinstall the wick and holder assembly into moistener.
5. Reinstall the moistener. Push down on the blue re lease lever on
the moistener.
Removing and Cleaning the Moistener Wick and Holder
i
NOTE: This procedure assumes you have done steps 1 to 7 from
the previous "Removing and Cleaning the Moistener Brush" section.
6. Slide the moistener back onto the machine. You should hear a
click as it engages.
Wick
Holder
Release
Lever
CLICK!
1. Pull up and remove the holder and wick from the moistener as
shown here.