Filter
Top Products
6
SP400RF
Programming Guide
GENERAL
INFORMATION
IF YOU MAKE A MISTAKE...
If, during a programming session, you find that you are unsure of the
scanner's settings or wish to re-set the scanner's configuration, use the
Return to Factory Settings label on this page to return the scanner's
configuration to the factory settings. Scanning this label will reset any
changes made during a previous programming session.
Appendix A contains a complete list of all standard factory settings.
WARNING
After returning the scanner to factory de-
faults, you must scan the BASE STATION I.D.
label (located on labels on the top and side of
the base station) and the CONFIGURATION
UPLOAD label as described below. This will
reestablish the communication link between
the scanner and base station, and complete
the restoration of the scanner's original con-
figuration.
RETURN TO FACTORY SETTINGS
Scan this label to return the scanner to the factory settings for the active
interface. It is unneccessary to scan “set” and “end” labels with this label.
CONFIGURATION UPLOAD
Use this option to upload the configuration file from the base station to
the scanner.
SET -------------------------------------
UPLOAD BASE STATION CONFIG -
END -------------------------------------