Filter
Top Products
68
SP400RF
Programming Guide
SYMBOLOGY
SELECTION
CODABAR
SET -------------------------------------
SET FIRST FIXED LENGTH ------
SET SECOND FIXED LENGTH ----
NO SECOND FIXED LENGTH -----
CODABAR FIXED LENGTH
All interfaces that are shipped with the standard factory settings are set to
read variable length labels for Codabar. If you switch from variable to
fixed length labels, the factory set fixed label lengths are 14 and 8. Follow
the steps below to change these defaults.
ENABLE FIXED
1. Identify the fixed length settings you want to make.
2. Scan the SET label.
3. Scan the Set First Fixed Length label.
SETTING LENGTHS
If you are setting a length less than ten, you must scan a zero first and
then the length digit (02, ...09).
4. Set the first fixed length label by scanning the correct digits
from the next page.
If you need to set a second fixed length, continue with step
five. If you do not need to set a second fixed length scan the
No 2nd Fixed Length label below and skip to step seven.