Filter
Top Products
B – Command Line Interface
Set Config Command
59042-06 A B-35
0
AutoPerfTuning Automatic performance tuning for FL_Ports only. The
default is True.
If AutoPerfTuning is enabled (True) and the port is
an FL_Port, MFSEnable is automatically enabled.
LCFEnable and VIEnable are overridden to False.
If AutoPerfTuning is disabled (False),
MFSEnable, LCFEnable, and VIEnable retain
their original values.
LCFEnable Link control frame preference routing. This parameter
appears only if AutoPerfTuning is False. Enables
(True) or disables (False) preferred routing of frames
with R_CTL = 1100 (Class 2 responses). The default
is False. Enabling LCFEnable will disable
MFSEnable.
MFSEnable Multi-Frame Sequence bundling. This parameter
appears only if AutoPerfTuning is False. Prevents
(True) or allows (False) the interleaving of frames in a
sequence. The default is True. Enabling MFSEnable
disables LCFEnable and VIEnable.
VIEnable Virtual Interface (VI) preference routing. This
parameter appears only if AutoPerfTuning is False.
Enables (True) or disables (False) VI preference
routing. The default is False. Enabling VIEnable will
disable MFSEnable.
MSEnable Management server enable. Enables (True) or
disables (False) management server on this port. The
default is True.
NoClose Loop circuit closure prevention. Enables (True) or
disables (False) the loop’s ability to remain in the open
state indefinitely. True reduces the amount of
arbitration on a loop when there is only one device on
the loop. The default is False.
IOStreamGuard I/O Stream Guard. Enable (Enable) or disables
(Disable) the suppression of RSCN messages. I/O
Stream Guard should be enabled only for ports
connected to initiator devices. The default is Disable.
PDISCPingEnable Enables (True) or disables (False) the transmission of
ping messages from the switch to all devices on a
loop port. The default is True.
Table B-9. Set Config Port Parameters (Continued)
Parameter Description